How to Install Wooden Floor

Besides being hard to wear and pretty, hardwood flooring is also very easy to install, which makes many people ask how to install their own wooden floor. This is not surprising; The wooden floor offers a variety of aesthetic options with options for hardwood floors and much better durability than other flooring options. From wood type to hardwood floor to floor pattern design, this floor definitely jual triplek suits your taste, taste, and circumstances. If installing a wooden floor is one of your options, you may want to read to learn how to install hardwood flooring.

Prepare the materials and tools you need. These are final nails, hammers, masking tape, tape measure, tied shovel, hardwood flooring glue, tapping block, hardwood floor stamping, pneumatic stapler, 1/4 “undercoat of plywood, and safety goggles.

Just a few notes before you start, remember that these even engineered and installed floors are not installed in the classrooms. This area has a greater risk of moisture damage. Instead, this flooring should be mounted on solid solid surface. If you are unsure about installing this floor above your current floor, check with the hardwood floor manufacturer first. But if you are, then you are ready to learn how to install this floor.

Measure the extensive footage of all areas where you want to install hardwood flooring. Do not forget to add 5% of the total to make wood scratches and other errors. It is also a good idea to prepare a whole area diagram. Open the floor strip package and let them adjust to the temperature and humidity of the house for at least 72 hours.

Remove all equipment and furniture from the room. Give enough permission for stationary equipment such as dishwasher. If there is gas equipment, it is better to hire a licensed plumber to disconnect for you.

Remove the shoe prints carefully as you can still reuse them after the installation is competing. You should also remove doorstep threshold, if any. Cut off the bottom of the door. Measure and cut the 1/4 “plywood and use it as a floor underlay.Assign plywood to the floor using nails or staples but a pneumatic stapler can make this task easier and faster.

Check the floor strips as some may have scratches, gouges, or broken areas. Measure and mark 12 inches from the right and left sides of the wall where you will start the installation. Dry floor strips. Slide the floor strips forward or backward to allow a 1/2-inch expansion slit between the last wall and strip.

The nail support board along the starting line on the side closest to the wall. You should also install floor boards to the center of the room as these boards will provide the support needed to touch the floorboard tightly.

Spread glue along the starting line by using a notched shovel. The shovel should be at a 45-degree angle for smooth and smooth folds. Make sure you use the correct glue because different wooden spans may use different adhesives. Now you can install floor boards. Do not install floor boards with two ends or close to each other. Tap both sides of the floorboard using the tapping block and make sure the line is tight.