How to Make a Turntable for 360 Degree Photography Product

360 degree product photography is a very complicated topic and involves because the products come in different shapes and sizes. Some may be highly reflective, some may have dimensions that will prevent you from dropping them onto the playtop, and some may have features that can only be highlighted when shot from a certain angle when hanging from above and with certain lighting settings.

The more obstacles you have in your 360 image setup, the less options you get to produce 360 ??smooth product views. It’s also very important to be able to quickly assess how your product jual blockboard emerges from different angles to the settings that existed before you started production of 360 actual product imagery.

So before you continue and spend your hard-earned money on computerized equipment (which is very valuable if you do this commercially), here’s a simple guide to make DIY turntable that will likely solve some of your photographic product needs. Good news? This will only cost you a trip to a hardware store (Ace Hardware or the like), $ 40 and one hour from your time to collect everything!

So a turning table will be built using two round plywood discs and a lazy susan pad installed between the discs to give smooth and steady motion. The pads are tough enough to handle weights up to 400-500 lb or even 1000 lb depending on the brand, so the weak link is plywood. If you go with Shepherd’s bearings, they come with pretty good assembly instructions. The key is finding and marking the center on a plywood disk. This is quite simple as long as the paws are perfect circle:

First, you need to find something that has a 90 degree angle like a piece of white paper. Place the corner of the right corner of the sheet at each point on the edge of the plywood disc and mark the other two points where it crosses the edge on the plywood. Then drag a straight line between two marks and connect the marks with a straight line. Now repeat the same procedure using another point on plywood. The intersection between two lines is the center of the disk.

The rest of the assembly is pretty easy – just follow the instructions on the bearing package!

Once the main job is done, you need to decide how many frames your 360 product display will consist of. Typically, 20 frames per view provides a good balance between the total image size / download speed and the smooth rotation of your product.

So to get 20 shots of the product, the turntable should be able to spin at 18 degrees. The key is to mark the top plywood discs in such a way that you can easily identify the increase. One approach is to put a number mark on the side of the disk. Since you’ve found the center on the top disk, creating a fairly simple 18 degree sign with a protractor.

The final step is to attach a piece of white paper at the top of the plywood disc where you will place your product and mark the measurements on the bottom of the plywood. Now plug your camera, align it with the measuring marks at the bottom and the center of the rotation, then place your product on the table and you are good to go.